The round silicone teat is suitable for all types of standard bottles. It vents perfectly and does not “stick” together during feeding. It is made of high-quality silicone that is completely tasteless and odorless and does not alter the taste of the food. Available in six flow sizes. When choosing a teat, also consider the child’s age, appetite, and the type of food served. Pack contains 2 pieces. Instructions for use: Before first use, sterilize the teat in boiling water for about 5 minutes for hygienic reasons. Before each subsequent use, wash the teat with a mild detergent in hot water, rinse thoroughly, and pour boiling water over it. Do not use any antibacterial agents! Do not leave the teat in direct sunlight, near a heat source, or in sterilizing solutions longer than recommended, as this may weaken the teat. Do not overtighten the screw cap, as the teat may not vent properly. Hard water, fruit juices, or teas may cause deposits or discoloration on the teat, which does not affect its properties. Do not pierce or enlarge the holes in the teat—you may damage it. For hygiene and safety reasons, we recommend replacing the teat after a maximum of 2 months. Important! For the safety and health of your child! Check the teat’s condition before each use. Pay extra attention once the child’s first teeth appear. Test the teat by pulling firmly in all directions. At the first signs of damage, discard the teat immediately and do not use it further. Use only under adult supervision. Never use the teat as a pacifier. Prolonged or continuous sucking of liquids can cause tooth enamel defects in children. Always check the temperature of the food. Warning! This product is not a toy. Keep out of reach of children. The teat complies with: Regulation (EC) No 1935/2004 of the European Parliament and of the Council—general requirements for materials and articles intended to come into contact with food, EN 14350-1 Child care articles—Drinking equipment—Part 1: General and mechanical requirements and tests, EN 14350-2 Child care articles—Drinking equipment—Part 2: Chemical requirements and tests.